Health Inspection Day

What inspectors actually look for

The difference between a routine inspection and a shutdown notice usually isn’t the food. It’s the paperwork, and a short list of physical things that are easy to get right once you know they’re on the list.

Inspectors aren’t looking for reasons to close you. They’re working a checklist. This guide walks that checklist in the order most inspections actually run, so nothing on it is a surprise.


Before they arrive

Inspections are often unannounced. The work is in being permanently ready, not in preparing the morning of.

Keep in the unit at all times:

  • Current permit or license, posted where it’s visible
  • Food handler certifications for everyone working — who needs one, and whether a certified manager must be on site, varies by jurisdiction
  • Commissary agreement, signed and current — required for mobile units in most jurisdictions
  • Your HACCP plan or written food safety procedures — a formal plan is required for specialized processes such as reduced oxygen packaging, curing, or sous vide
  • Temperature logs, current and filled in
  • Cleaning and sanitizing schedule
  • Employee illness policy
  • Previous inspection report and proof you fixed anything noted

The single most common finding: temperature logs that are blank, or filled in all at once in the same pen. An inspector can tell. A log completed honestly with a gap and a note explaining it reads far better than a perfect one that’s obviously fiction.


The five things they check first

1. Temperature control

This is where most violations are written.

  • Cold holding at 41°F (5°C) or below
  • Hot holding at 135°F (57°C) or above — FDA Food Code 3-501.16
  • Cooking temperatures met for each product type — see the table below
  • Cooling done in two stages: 135°F down to 70°F within 2 hours, then 70°F down to 41°F within 4 more — six hours total, and the first two are the ones people miss (Food Code 3-501.14)
  • A working, calibrated probe thermometer on hand
  • Thermometers in every cold-holding unit

Cooking temperatures, from the FDA Food Code:

Product Minimum
Poultry, stuffed meats, stuffing containing meat 165°F, instantaneous
Ground or comminuted meat and fish 155°F for 17 seconds
Whole-muscle meat, fish, eggs cooked to order 145°F for 15 seconds

Calibrate your probe and write down when you did it. In an ice-water slurry it should read 32°F. An uncalibrated thermometer makes every log entry questionable.

2. Handwashing

  • Dedicated handwashing sink, not the prep or dish sink
  • Hot water at the hand sink. This number changed: the 2022 Food Code lowered the minimum from 100°F to 85°F (5-202.12(A)). States adopt the Code at different versions, so yours may still require 100°F — build to the higher number and you are right either way
  • Soap and single-use towels stocked
  • Sink unobstructed — nothing stored in or in front of it
  • Handwashing signage posted at every hand sink

The unobstructed part gets people. A case of cups in front of the hand sink is a finding even if everything else is spotless.

3. Cross-contamination

  • Raw proteins stored below and away from ready-to-eat food
  • Separate cutting boards or a documented sequence
  • Sanitizer bucket made to the right concentration, with test strips to prove it
  • Clean wiping cloths stored in sanitizer, not on the counter
  • Gloves changed between tasks. No bare-hand contact with ready-to-eat food — Food Code 3-301.11. This is a priority item, not a suggestion

4. Water, waste, and the physical unit

  • Potable water tank filled, and the correct size for your unit. Minimum tank capacity for mobile units is set locally and varies widely — confirm yours
  • Wastewater tank larger than the fresh water tank — commonly required to be at least 15% larger, though the exact margin is set by your jurisdiction
  • Three-compartment sink for wash, rinse and sanitize, plus a separate hand sink. Some jurisdictions approve alternatives for small units — ask before you build
  • No leaks, no standing water
  • Surfaces smooth, non-absorbent, and cleanable
  • Screens intact; no gaps where pests get in
  • Adequate lighting, shielded or shatter-resistant over food and prep areas

5. Personal hygiene and employee health

  • Hair restraints worn
  • Clean outer clothing
  • No eating, drinking, or smoking in prep areas
  • No jewelry on hands or wrists beyond a plain ring band — Food Code 2-303.11
  • A written illness policy, and staff who know when to stay home
  • No one working while sick. The reportable symptoms are vomiting, diarrhea, jaundice, sore throat with fever, and infected lesions on hands or wrists

What turns a finding into a shutdown

Most findings are corrected on the spot and noted. A small number are treated as imminent health hazards and can close you the same day. The Food Code lets a regulator suspend operation immediately for these, and most jurisdictions mirror the list. Get your own jurisdiction’s version, because this is where local variation actually bites:

  • No hot water, or no water at all
  • No refrigeration, or cold-holding badly out of range
  • Sewage backup or wastewater discharge
  • Active pest infestation
  • No permit, or an expired one
  • Working without required certification
  • Refusing entry to the inspector

If you’re told to stop: ask what specifically must change to reopen, get it in writing, and ask who to call when it’s done. A shutdown for no hot water can end the same afternoon.


During the inspection

Do: greet them, put down what you’re doing, walk with them, answer plainly, take notes, fix what can be fixed on the spot, ask them to explain anything unclear.

Don’t: argue in the moment, guess at an answer, or hide something. “I don’t know, let me find out” is a perfectly good answer. A guess that turns out wrong costs you credibility for the rest of the visit.

Ask before they leave:

  1. What did you find, and which are critical?
  2. What’s my deadline to correct each one?
  3. Do you need proof, or will you re-inspect?
  4. Is there anything you’d flag as trending toward a problem?

That last question is the useful one. Most inspectors will tell you.


After

  • Read the full report the same day
  • Correct critical items immediately
  • Photograph each correction with a date
  • File the report with your permanent documents
  • Fix the cause, not just the instance — if a log was blank, change who fills it in and when

The one-page pre-shift check

Run this before every service and most findings never happen:

  • Thermometer calibrated and in the unit
  • All cold units in range, logged
  • Hand sink stocked and clear
  • Sanitizer mixed and tested
  • Water tanks filled, waste tank has room
  • Certifications and permit in the unit
  • Today’s temperature log started
  • Nobody working sick

Good food shouldn’t get stopped by bad paperwork.


Where these numbers come from

The temperatures, times and priority items above come from the FDA Food Code — the model code almost every US jurisdiction builds on. Checked against the 2022 edition on September 6, 2026.

The catch worth knowing: the Food Code is a model. States adopt it on their own schedule and amend it, so a state can be running the 2013, 2017 or 2022 edition, with local changes on top. That is exactly why the hand sink number differs depending on who you ask — it moved from 100°F to 85°F in 2022, and plenty of states have not adopted that yet. Where a number matters to you commercially, confirm which edition your jurisdiction is on.


This guide is for informational purposes only. Always verify requirements with your local health department or regulatory agency.